Remember this card? Time sure did get away from me. Here are the instructions for the Sangria Slider Card I posted here. Writing the steps out proved to be a little more difficult than I imagined. I wrote them, re-wrote them, and tweaked them a little more. I'm sure they are far from perfect, but you should be able to recreate the card by following the steps outlined. Don't hesitate to ask for clarification if you need it.
Slider
Card Instructions
Finished card size 4 ¼ x 5 ½
Front (Chevron B&T) 4 ¼ x 5 ½
Back (Pomegranate CS) 4 ¼ x 5 ½
Inside Sentiment (Colonial White CS) 3 ¼
x 4 ½
Slide Piece (Colonial White) 3 1/8 x 4
3/8
Mat (Pomegranate) 2 ¾ x 4
Focal Piece (Colonial White) 2 7/16 x 3
1/8
Prepare
Front:
1. Align 5 ½ inch
side along 1 inch on paper cutter. Start cutting blade at 4 ½ inch mark and cut
to 1 inch mark.
2. Turn piece ¼ turn.
Align 4 ¼ inch side along 1 inch on paper cutter. Start cutting blade at 3 ¼ inch
mark and cut to 1 inch mark.
3. Turn piece ¼ turn.
Align 5 ½ inch side along 1 inch on paper cutter. Start cutting blade at 4 ½ inch
mark and cut to 1 inch mark.
4. The uncut 4 ¼ inch
side will be the top of the card. Align the top along 1 inch on the paper
cutter. Score between the cut lines.
5. Slide the top to
align along 2 ½ inch on the paper cutter. Score between the cut lines.
6. Slide the top to
align along 4 inch on the paper cutter. Score between the cut lines.
7. From the top,
fold the scored lines valley-hill-valley.
Prepare
Back:
1. Adhere inside
sentiment to card back, centered.
2. Apply adhesive
around sides and bottom of card back as close to inside sentiment as possible.
3. Attach front
piece to back piece, aligning tops of each piece.
4. Find the center
of the top edge and punch a thumb notch (you can use the new thumb notch punch
or half of a 1” circle punch).
Slider:
1. Insert slider
piece between top and bottom of card.
2. Apply adhesive to
the back side of the ½ inch scored flap of front piece, align with bottom edge
of slider piece, and adhere.
3. Cut ¾ inch off of
mat to create two pieces measuring 2 ¾ x 3 ¼ and 2 ¾ x ¾
4. Apply adhesive to
top side of the center scored flap on card top. Attach 2 ¾ x 3 ¼ mat.
5. Apply adhesive to
top side of ½ inch scored flap on card top. Attach 2 ¾ x ¾ mat aligned with
larger mat.
6. Stamp/decorate
focal piece.
7. Attach focal
piece to 2 ¾ x 3 ¼ mat piece (centered).
8. Embellish 2 ¾ x ¾
mat piece as desired (zip strips, complements, twine, ribbon, etc.)
9. Stamp sentiment
on inside of card.
Thank you for stopping by today and for being so patient!
